No Scan Results - NVT 0/0

[cfi]

Please install the latest GCE release 4.3.14. There was a bug fixed most recently in GOS:

Bugfix: In some cases the default quality of detection for all vulnerabilities was set to 75% due to the OpenVAS manager not correctly generating its internal metadata database (#108670).

Roadmap und Lifecycle - Greenbone

which might be responsible for this seen behavior reported here.

Additionally even with the newest version the following still applies:

@cfi

Please also note the following of https://www.greenbone.net/en/install_use_gce/ :

The feed update now runs in the background and you are on the main menu of the administration. Via “About” you can have a look at the key properties of your setup, especially the address of the web interface and whether there still runs the Feed update as a system operation.

Only after the feed update completed there will be all information in the SecInfo area and first scans possible. This could take half an hour or even longer.

Even if the GSA is telling you that the feed versions are current the initial feed sync and the rebuild of the database might still run. So if you’re getting an NVT count of 0/0 please have some more patience, especially for the first sync after the initial setup of the appliance.

For some reason my fresh GCE 4.3.14 installation has shown a “feed not reachable” message during the first setup causing a 0/0 count of NVTs as well. A subsequent trigger of the feed update via Maintenance → Feed → Update in the GOS menu has started a full sync again.