Operating system: Debian 10 Buster
Virtualization: Parallels Desktop 16
Installation method / source: Github 20.08 Branch from Source, using guide https://kifarunix.com/install-and-setup-gvm-20-08-on-debian/
Description of Issue
I’m having similar a similar issue that others have faced where I cannot launch scans from the GUI as I get error 'failed to load scan config. I have reviewed other posts and attempted the all historically listed steps.
Set the feed owner
gvmd --modify-setting 78eceaec-3385-11ea-b237-28d24461215b --value 02d66dd3-5403-488d-9908-7948b0c4beb4<which is the uuid obtained from
Syncing all nvts with ospd-openvas
greenbone-nvt-sync -type GVMD_DATA
sudo openvas --update-vt-info
gvmd --modify-scanner=08b69003-5fc2-4037-a479-93b440211c73 --scanner-host=/opt/gvm/var/run/ospd.sock
Every aspect of the build has been clean, services are active. However, I get errors in ospd-openvas.log
OpenVAS Scanner failed to load VTs. Command '['openvas', '--update-vt-info']' died with <Signals.SIGABRT: 6>
Curiously, the OpenVAS service only shows 4 tasks (where install guide had 6) and --update-vt-info is not listed in CGROUP:
I’m at wits end with this. Does anyone have ideas?