@dresc
So I’ve followed all of the same steps here, but I ran into an issue with the last two commands here.
The first one says that there is a syntax error in the setting value, but it works when I try my userid
the second command says scanner not found, but it works when I use the openvas default scanner id
but even after I run those commands, I still get the same error when I try to scan.
Any Thoughts?
dresc
February 28, 2022, 9:33pm
43
Hi @cfi
Thanks again for the support, I’ll save these links, in case I need to solve this problem again in the future.
1 Like
dresc
February 28, 2022, 9:39pm
44
Hi, @SirScotty
This case I reproduced, exactly the same commands that @filo performed in some interactions in this post, above! Did you get to see them? It was on Mar 21, his second post.
For the solution what I found was:
Go to Administration - new User and create a new user with administrator role.
I close session I stop the service:
sudo gvm-stop
start the service:
sudo gvm-start
you access with the new user and ready you can create your tacks.
PD.: My english is bad.